This has worked in the past, but when we try to program the VEX today we get an error:
The following error was encountered during evaluation of the DownloadCommand command:

An error was encountered while downloading the generated binary file to the hardware.
Uniflash v0.7 by Stephen Carlson
Error: no matching ports found for this board (VexFlash); currently connected:
This is on a Mac, and I see the VEX enumerate on the USB bus:

CDC RC Controller:


  Product ID:0x000b

  Vendor ID:0x04d8  (Microchip Technology Inc.)


  Speed:Up to 12 Mb/sec

  Location ID:0x14100000 / 8

  Current Available (mA):500

  Current Required (mA):500


Quote 0 0